The Vespa Guide
http://vespaguide.com/?p=956
Export date: Sat Nov 23 18:11:07 2024 / +0000 GMT

Vespa Large Frame Gearing




Source: Scooterhelp.com

The Vespa gearbox has used basically same set up since the first bike rolled off the assembly line. Small frames, wide body bikes, and large frames all use variations of this system.

Below is an overview of a typical large frame Vespa gearbox

vespa_gearbox_input3

  1. The Primary Drive - A small gear is attached to the drive plate of the clutch and it mates with a helical cut gear which is riveted to the input shaft. These rivets can be drilled out to change the primary drive but usually the small clutch gear must also be changed.

  2. The Input Shaft- This has the 3 or 4 gears machined into a single piece sometimes called a 'Christmas Tree'. The kickstart gear turns on the end of this shaft.

  3. Output Shaft/ Separate Gears- These mesh with the Christmas Tree and a small selector engages a single gear with the output shaft.




The Primary Drive

vespa_gearbox_output4

This is where the Vespa gearbox is less flexible then the Lambretta gearbox. In most cases the large helical gear and the smaller clutch gear must be changed as a pair. In comparison, a Lambretta gearbox allows each of these two items to be changed independently because a larger chain can take up the slack. With a Vespa, if one gear diameter increases the other must decrease because since they physically meet, their relationship must always be the same. There are kits on the market from Polini and Malossi that require drilling the rivets out of the gears and allow you to retain the standard Christmas tree gear cluster, while changing the primary drive to a higher, non-standard ratio.

 

The Input Shaft


vespa_gearbox_over1



Other than a few exceptions the input shaft gears and the separate gears on the output shaft must be changed as a pair. An exception is the T5 4th gear that can be installed in a P200 standard box to give higher RPM in 4th gear. Most after market expansion chambers create more power at higher RPMs than the standard exhaust, but less power than a standard exhaust at lower RPMs. There is a larger gap between the P200E 3rd and 4th gears than any other gear gap. This means that with an expansion chamber you may not have the power to reach the type of RPMs the pipe needs to perform well in 4th gear. Surprisingly if you make the gap smaller you may actually have a faster top speed

The Output Shaft


vespa_gearbox_primary2


The output shaft gears are independently machined but should always go in as a group. This is the final drive, and a small machined cross locks each gear rotation independently to the output shaft rotation which is rigidly attached to the rear wheel. So all the gears spin when the bike is moving, by rotating freely on the output shaft, but only one gear at a time drives the shaft. The metal cross is moved up and down the output shaft by the gear twist grip on the handlebars.


 
Post date: 2015-11-30 06:36:16
Post date GMT: 2015-11-30 06:36:16

Post modified date: 2015-11-30 06:36:16
Post modified date GMT: 2015-11-30 06:36:16

Export date: Sat Nov 23 18:11:07 2024 / +0000 GMT
This page was exported from The Vespa Guide [ http://vespaguide.com ]
Export of Post and Page has been powered by [ Universal Post Manager ] plugin from www.ProfProjects.com