This page was exported from The Vespa Guide [ http://vespaguide.com ]
Export date: Fri Apr 27 4:27:42 2018 / +0000 GMT

Vespa Oil Seals Maintenance: Flywheel Side




Courtesy ScooterHelp.com

Oil Seals: Flywheel Side

There are three main oil seals in a Vespa engine:

There are also some more minor seals around the kickstart quadrant, the clutch cover, and the rear wheel back plate.

The main seals should be replaced every time the engine is taken apart as they are cheap to buy but they are buried pretty deep in the engine. If you have the engine apart you might as well drop them in.

Flywheel side seal: The flywheel side seal on a typical P series motor is shown below on the left once the stator plate and crank have been removed. The seal is the black rubber like ring visible just in front of the bearing. It can be removed with a small screwdriver if care is taken not to damage the roller bearing beyond as shown on the right. This is also possible to do with the crank still in the machine but the clutch side seal is not.

flyside_seal1 flyside_seal2

Fitting a new flywheel side seal is as simple as pushing the seal into place firmly with equal pressure on all sides as shown below.

flyside_seal4 flyside_seal5

 

 


Post date: 2016-03-20 23:26:30
Post date GMT: 2016-03-20 23:26:30
Post modified date: 2016-03-20 23:26:30
Post modified date GMT: 2016-03-20 23:26:30

Powered by [ Universal Post Manager ] plugin. MS Word saving format developed by gVectors Team www.gVectors.com